Counter and time delay in 8085 microprocessor

What is meant by segment memory in and ? AA0 will be the address of the MVI instruction. Of course, it's often better to use the pushes and pops inside the subroutine. What is the role of clk in microprocessor? What is the purpose of the out instruction in microprocessor?

Uploader: Arakazahn
Date Added: 25 March 2006
File Size: 38.97 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 83881
Price: Free* [*Free Regsitration Required]





Given here is a flowchart depicting the process for making time delays using a single register in the Microprocessor. It can be used to develop bus control logic, because it is micropfocessor the inverse of ALE for one half clock cycle.

Instruction Register and Decoder. Type of DAC in microprocessor?

What are time delays in ? - Quora

Instruction register is 8-bit register just like every other register of microprocessor. What is T states in counters and time delay in microprocessor? This is similar to block diagram with the following difference. But Registers and ALU alone cannot successfully micrlprocessor a data and provide the result to the programmer. A subroutine is a group of instructions that will be used repeatedly in diff locations of the program How do you draw timing diagram for microprocessor XTHL instruction? The address data buffer can both send and receive data from internal data bus.

What is interfacing with microprocessor? These buffers are then used to drive the external address bus and address-data bus.

Sorting conuter a program and, as such, is not dependent on which microprocessor is involved. But processor requires 16 bit address bus as the memory addresses are bit wide. The eight bit data bus is multiplexed with the eight least significant bits of address bus.

Each flag is set or reset, for certain instructions only, based on the result of that instruction. How do you draw timing diagram for microprocessor hlt instruction?

The processor calls the subroutine, address of which is specified in the second and third bytes of the instruction. The carry flag is set delzy a carry is generated and reset whenever there is no carry.

Intel processors have a set of 5 flags. Consider that a microprocessor is executing the main program. X Octal op code where X is a 3-bit code. What is Zero flag in ? What is the internal architecture of 805 P P Parity Bit 2. What are the counters and time delays in ? Save your draft before refreshing this page. An 8-bit stack pointer is used to hold the address of the most recent stack entry.

Among the maskable interrupts RST 7. What is READ pin in in microprocessor? Gaonkar a better one. Ask New Question Sign In.

If it is zero the flag returns value 1. If READY is found to be false lowthe processor holds the state of all lines for one clock cycle and then repeats. Z Z Zero Bit 6. It alerts the processor that some event has taken place.

0 thoughts on “Counter and time delay in 8085 microprocessor

Leave a Reply

Your email address will not be published. Required fields are marked *